The high-density, ceramic-based thermal compound specifically designed for modern high-power Peltier Elements and high-performance heatsinks or water-cooling solutions.
Made with micronized aluminum oxide, boron nitride and zinc oxide.“Ceramique” uses a high-density layered composite of five unique shapes of thermally conductive alumi-num oxide, boron nitride and zinc oxide sub-micron particles to maximize particle-to-particle contact area and thermal transfer.
This exclusive combination provides performance exceeding most metal based compounds.
Average particle size: 0.38 µm <0.000015 inch
Controlled triple phase viscosity.
“Ceramique” does not contain any silicone. The suspension fluid is a proprietary mixture of advanced polysynthetic oils that provide superior performance and long-term stability.
During the system's initial use, the heat from the Peltier Elements lowers the viscosity of the compound to enhance the filling of the microscopic valleys and ensure a minimum bond line between the heatsink and the Peltier Element core. Then the compound thickens slightly over the next 100 to 300 hours of use to its final consistency designed for long-term stability.
(This should not be confused with conventional phase change pads that are pre-attached to many heat-sinks. Those pads melt each time they get hot then re-solidify when they cool. The viscosity changes that Ceramique goes through are much more subtle and ultimately much more effective.)
“Ceramique” is engineered to not separate, run, migrate, or bleed.
“Ceramique” does not contain any metal or other electrically conductive materials. It is a pure electrical insulator, neither electrically conductive nor capacitive.
Wide Temperature Limits.
Peak: – 40°C to > +180°C
Long-Term: – 40°C to +140°C
Easy Clean Up.
“Ceramique” can easily be cleaned from Peltier Elements and heatsinks with isopropyl alcohol or any of the cleaners listed in the product instructions.
The 2.7-gram “Ceramique” is the first product available in our proprietary thermal compound syringe. Our new syringe is more compact, easier to handle and dispenses a higher percentage of its content than standard industrial or medical syringes. The amount of compound remaining in the syringe is easy to determine as the rear of the plunger is perfectly flush with the flange when the syringe is empty.
Syringes with 2 ml, 4 ml, 8 ml, 16 ml also are available.